border cannot be superposed Here users need to set (Page 58 / 72) LabelMark Marking Software Manual, v3.6

EzCad2UNI User’s Manual

border cannot be superposed. Here users need to set the Acc Distance Parameter (Values from

0.05 to 0.25). But this may cause the 4th case: the hatch-lines are beyond the border, as Figure

10-9 shows. Users may increase the Start TC Value or lower the Acc Distance Parameter, and if

the two parameters are adjusted well, there will be a perfect result.

� Adjust End TC:

Still mark the hatched rectangle mentioned above

Here are three possible cases about the hatch-lines and the border’s relative positions.

Case #1: The fill-lines and the border are separated, as Figure 10-10 shows. This is because

the End TC is too short, and users need to raise it.

Figure 10-10 Case #1

Figure 10-11 Case #2

Case #2: Burn-in effect as Figure 10-11 shows. This is because the End TC is too long, and

users need to shorten it.

Case #3: Perfect result as Figure 10-12 shows.